Backing up your data is an important part of any software system. TNA 2000 makes it a bit easier by including a customised backup module. This module allows for both manual and unattended backups.

This document describes how to set up your machine so that backups happen on a scheduled basis.

Related Articles

To Run

The backup module is a program called Backup32.Exe. This can be found in the same directory as your other TNA 2000 programs. 

Tip : If you're not sure where your TNA 2000 programs are located, then check the shortcut in the Start Menu. If you Right-Click on the shortcut, then you'll be able to get the full path to the program.

In order to tell the program to run in unattended mode, you must add the following command line switch;

PATH=C:\BACKUP\

Tip : Notice the trailing backslash. Inserting the trailing backslash is required for versions prior to 3.08.